Smoke odor lingering weeks after cleanup
We locate the source with air sampling, treat porous materials with hydroxyl generators and thermal fogging solution, and verify with a follow-up reading. If the smell returns, we re-treat at no charge.
Commercial Fire Restoration in PLAYA DEL REY, California means getting your doors open again, not just sweeping up ash. We handle board-up, soot removal, smoke odor, and water damage from firefighting in one crew, and we document every step for your insurer. Whether a kitchen hood fire shut your Culver Boulevard Corridor restaurant or a Ballona Wetlands-adjacent warehouse took smoke damage, we mobilize same-day and work around your operating hours.

Commercial Fire Restoration in PLAYA DEL REY, California is the process of stabilizing a fire-damaged business, removing soot and smoke residue, drying water left by firefighting, and rebuilding the structure to code so you can reopen. It is not a cleaning job. Charred framing, melted wiring, and smoke-damaged HVAC all have to be addressed before an inspector signs off. We start with thermal imaging cameras to find hidden heat pockets and moisture meters to map water intrusion, then sequence the work so trades do not trip over each other.
Most PLAYA DEL REY business fires we see start small: a kitchen hood flare-up, an electrical panel arc, a dryer vent clog. The damage rarely stops at the burn. Smoke travels through ductwork and settles into inventory, and water from suppression lines soaks drywall and insulation. That combination is why commercial fire damage restoration PLAYA DEL REY California calls for one team handling fire, smoke, and water together. If you are searching for commercial fire restoration near me in PLAYA DEL REY California at 2 a.m., we answer and dispatch.
Every commercial loss is different, but the core scope below is what we bring to a PLAYA DEL REY business fire. Anything outside it, like content pack-out or specialty equipment restoration, gets scoped and priced separately so you can see exactly what you are paying for.
Openings get boarded, broken glass gets replaced with plywood, and utilities are shut off where needed. This happens on the first visit, usually within 60 to 90 minutes of your call.
HEPA vacuuming, dry-chemical sponges, and sanding blocks on walls, ceilings, and framing. We seal remaining structure with smoke sealant so odor does not bleed back through fresh paint.
Standing water from firefighting gets extracted, wet drywall and insulation come out, and air scrubbers and dehumidifiers run until moisture meters read dry against a known baseline.
Hydroxyl generators, ozone in unoccupied zones, and thermal fogging solution in ductwork. We verify with air sampling before we remove equipment, not just by smell.
Drywall, insulation, lumber, and plywood replacement, fire-rated caulk at penetrations, and finish work to pre-loss condition under our California State Contractor License (B-1 General Building).
Photos, moisture readings, measurements, and a written scope formatted for your adjuster. This is the file that gets commercial fire damage restoration PLAYA DEL REY California claims approved without a second site visit.
We take your call 24/7 and roll a crew to your PLAYA DEL REY address, usually within 60 to 90 minutes. First job is safety: we shut off utilities if the fire department has not, check for structural movement, and board up openings so your building is not sitting open overnight.
Within the first few hours we walk the building with thermal imaging cameras and moisture meters, map every affected zone, and photograph the damage. You get a written scope and a preliminary cost range before demolition starts, so there are no surprises when the invoice arrives.
Crews HEPA-vacuum loose soot, then use dry-chemical sponges and sanding blocks on charred framing and smoke sealant on the remaining structure. Standing water from suppression lines gets extracted and wet drywall and insulation come out. This phase usually runs 2 to 4 days on a mid-size commercial space.
Air scrubbers, negative air machines, and dehumidifiers run until moisture meters read dry against a known baseline, which takes 3 to 5 days on average. In parallel we run hydroxyl generators or ozone in unoccupied zones and fog ductwork with thermal fogging solution to kill the smoke smell at the source.
We replace drywall, insulation, lumber, and plywood, seal with fire-rated caulk where code requires it, and finish to pre-loss condition. Before we hand back keys, we walk the space with you, verify odor and moisture readings, and leave a documentation packet for your insurer and your file.
Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.
Find hidden heat pockets in walls, ceilings, and attic spaces so we do not open a wall that is fine or miss charring that is not.
Capture airborne soot particles and keep smoke from migrating into unaffected areas of your building during demolition.
Neutralize smoke odor at the molecular level in occupied and unoccupied zones, including inside ductwork and soft contents.
Map water intrusion from firefighting and confirm the structure is dry against a known baseline before we close walls.
Remove fine soot residue from surfaces without pushing it deeper into drywall, fabric, or HVAC components.
Pull moisture out of the air and structure fast enough to beat the 24 to 48 hour mold window after a fire.
Open walls cleanly for inspection and remove charred material without damaging structure that can be saved.
A hood fire coated a 1,400 sq ft kitchen line in grease and soot and melted a section of ductwork. The owner was facing a health inspection failure and a full week of lost covers.
We degreased every surface, replaced the damaged duct section, treated the kitchen with thermal fogging solution, and passed re-inspection on day six. The owner reopened for Friday dinner service.
An electrical panel fire in a Silicon Beach office pushed smoke through shared HVAC into three suites. Two tenants were ready to relocate rather than wait out a long repair.
We isolated the affected unit with negative air machines, cleaned the ductwork, replaced charcoal filters, and rebuilt the panel wall. All three suites were back in service in 12 days, and no tenant moved.
A Manchester Square warehouse fire left charred framing and roughly 400 gallons of suppression water on the floor. Moisture meters showed wet drywall across two walls.
We extracted the water, dried the structure in four days, replaced charred lumber and plywood, and sealed with fire-rated caulk. The building passed inspection and returned to storage use in four weeks.
The fire is the headline. The problems that follow are what keep your doors closed. Here are the ones we hear most from PLAYA DEL REY business owners, and how we handle them.
Ask a pro →We locate the source with air sampling, treat porous materials with hydroxyl generators and thermal fogging solution, and verify with a follow-up reading. If the smell returns, we re-treat at no charge.
We extract standing water the same day, pull wet materials, and run air scrubbers and dehumidifiers until moisture meters read dry. Drying starts before demolition finishes.
We photograph, measure, and log every affected zone and hand your carrier a packet formatted the way they expect. Business owners searching for commercial fire restoration near me with insurance PLAYA DEL REY California get a crew that speaks the adjuster's language.
We coordinate licensed electricians for panel and wiring inspection, clean or replace smoke-damaged HVAC components, and swap charcoal filters and HEPA filters before the system goes back online.
Most commercial fire restoration jobs in PLAYA DEL REY run $8,000 to $60,000, with small retail or office losses near the low end and restaurant or warehouse rebuilds at the top. Square footage, smoke spread through HVAC, water damage from suppression, and whether the rebuild is cosmetic or structural drive the number. We give you a written range before demolition so you can compare it to your policy limits.
We do, and we are local. Fire Damage Restoration Playa Del Rey handles commercial fire damage restoration PLAYA DEL REY California calls 24/7, with crews that know the building stock from Culver Boulevard Corridor to Pacific Avenue. We are licensed, insured, and bonded, and we work directly with landlords, tenants, and property managers on multi-tenant losses.
We sequence the job so revenue-generating areas reopen first. That usually means isolating the burn zone with negative air machines, restoring the front of house or sales floor while the back is rebuilt, and scheduling loud work outside your open hours. Most small commercial losses reach a dry, odor-free, usable shell in 5 to 10 working days.
Plan on 2 to 4 weeks for a typical commercial loss: 2 to 4 days of soot and water removal, 3 to 5 days of drying and odor control, and 1 to 3 weeks of rebuild depending on permits and material lead times. A single-room kitchen fire can wrap in 10 days. A warehouse with smoke-damaged HVAC and structural charring can run 6 weeks or more.
One call gets a crew moving, a scope written, and your insurer looped in. We are licensed, insured, and bonded, and we answer 24/7. Call (833) 929-6186 now and tell us what burned.
Call Now (833) 929-6186 →Our line is answered 24 hours a day, including holidays. Call (833) 929-6186 and a technician will ask a few questions about the fire, the structure, and whether anyone is still inside, then dispatch a crew. Most PLAYA DEL REY calls get a team on site within the hour.