Soot, smoke, and charred wiring removed by a licensed crew

Electrical Fire Cleanup in PLAYA DEL REY, California

Electrical Fire Cleanup in PLAYA DEL REY, California starts with shutting down the danger and ends with a home that smells and tests clean. We pull charred wiring, HEPA-vacuum soot off every surface, and run air scrubbers until particles drop. Whether a breaker panel arced in a Culver Boulevard corridor condo or an outlet fried behind a bedroom wall in North Playa del Rey, our crew handles the mess and the paperwork. Call (833) 929-6186.

↗
Fast online booking

Request service today

Tell us what is happening. Our local team will confirm your visit shortly.

No spam. No obligation. Just practical help.
Thanks — we'll call shortly to confirm your visit.
Fire Damage Restoration Playa Del Rey — your local Fire Damage Restoration team
Careful work. Honest options.
About this service

What Electrical Fire Cleanup in PLAYA DEL REY, California Involves

Electrical Fire Cleanup in PLAYA DEL REY, California is the specialized removal of soot, char, smoke residue, and contaminated materials left after a wiring, outlet, panel, or appliance fire. It is not the same as general house cleaning. Protein-based smoke from an electrical fire clings to drywall, insulation, and lumber, and it carries an acrid odor that returns every time humidity rises. Our technicians use thermal imaging cameras to find hot spots inside walls, then open the cavity with drywall saws and pry bars to remove melted wiring and charred framing before any surface gets sealed.

Most electrical fires we see in PLAYA DEL REY start small: a failed GFCI in a bathroom, an overloaded power strip behind a TV, or aluminum branch wiring in a 1960s duplex near Loyola Village. The damage is often hidden inside the wall cavity, which is why a visual inspection is not enough. If you are searching for electrical fire cleanup near me in PLAYA DEL REY California, the first step is a full scope that includes the attic, the panel, and the HVAC. We document everything for your insurance carrier before a single item leaves the property.

  • ✓ Soot Removed, Not Smeared
  • ✓ Odor Killed at the Source
  • ✓ Wiring and Panel Made Safe
  • ✓ Insurance Documentation Done Right
What's included

What Our Electrical Fire Cleanup Includes

Every job starts with a documented scope, and the standard package covers the work that gets your home safe and livable again. If the fire reached the attic or the HVAC system, we add those to the same scope rather than handing you off to a second contractor.

✓

Emergency Board-Up and Power Isolation

We secure open walls, windows, and doors and confirm the affected circuits are off before anyone works inside the burn zone.

✓

Soot and Char Removal

HEPA vacuuming, chemical sponges, and controlled demolition of charred drywall, insulation, and lumber, with melted wiring cut back and bagged.

✓

Air Scrubbing and Deodorization

Negative air machines, air scrubbers with HEPA filters, and hydroxyl or ozone treatment sized to the room volume and run until the odor test passes.

✓

Moisture and Thermal Documentation

Thermal imaging and moisture meter readings logged room by room, with photos, so your adjuster can price the scope without a second visit.

✓

Sealing and Rebuild Handoff

Fire-rated caulk and smoke sealant on exposed cavities, then a clean handoff to drywall, paint, and trim so the rebuild starts on schedule.

How it works

How Our Electrical Fire Cleanup Process Works

01

Emergency Response

Call (833) 929-6186 and we roll a crew with negative air machines and board-up materials. We confirm the power is off, secure open walls and windows, and stop water from firefighting from spreading into adjacent rooms. Same-day electrical fire cleanup PLAYA DEL REY is available around the clock.

02

Scope and Documentation

We map the burn zone with thermal imaging cameras and moisture meters, photograph every affected surface, and write a room-by-room scope. You get a copy for your insurance adjuster the same day. This is the step that prevents surprise denials later.

03

Soot and Char Removal

Crews HEPA-vacuum ceilings and walls, then remove charred drywall, insulation, and lumber with drywall saws and pry bars. Melted wiring is cut back and bagged. We seal the exposed cavity with fire-rated caulk and smoke sealant before reconstruction begins.

04

Deodorization and Air Cleaning

Air scrubbers with HEPA filters run continuously while hydroxyl generators and ozone generators treat the structure. We thermal-fog with a smoke sealant to reach the inside of cabinet boxes and wall cavities. Expect 24 to 72 hours of equipment run time before the odor test.

05

Clearance and Rebuild Handoff

We walk the job with you, take final moisture and photo documentation, and hand off to the rebuild crew for drywall, paint, and trim. If you need structural repair after fire, the same company carries it through so you are not coordinating two schedules.

Tools & methods

Tools and Methods We Use

Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.

Thermal Imaging Cameras

Find hot spots and hidden char inside wall cavities before demolition so we open only what needs opening.

HEPA Vacuums

Capture fine soot particles instead of pushing them into the air, the first step on every ceiling and wall.

Air Scrubbers and Negative Air Machines

Turn room air 6 to 8 times per hour and keep soot from migrating into clean rooms during demolition.

Hydroxyl and Ozone Generators

Neutralize odor molecules in wall cavities, cabinet boxes, and HVAC components that wiping cannot reach.

Moisture Meters

Log readings in framing and drywall so we know what is wet from firefighting and what is merely smoky.

Drywall Saws and Pry Bars

Controlled removal of charred drywall and lumber with minimal damage to adjacent finished surfaces.

Dri-Eaz and Phoenix Restoration Equipment

Commercial air movers and dehumidifiers that dry firefighting water before mold growth after fire becomes a second claim.

Real results

Before and after.

Garage Panel Fire, North Playa del Rey

Before

A failed breaker arced and burned a 4-foot section of wall behind the panel. Soot covered the garage ceiling and drifted into the adjoining laundry room. The homeowner had been told the smell would fade on its own after two weeks.

After

We removed the charred drywall and framing, HEPA-vacuumed the ceiling, and ran air scrubbers for 48 hours. The cavity was sealed with fire-rated caulk and the electrician replaced the panel. The laundry room passed an odor test on day four.

Outlet Fire in a Del Rey Lagoon Condo

Before

An overloaded power strip failed behind a bedroom TV and scorched the outlet box. Smoke moved through the shared HVAC chase into the unit above, leaving a light film on walls that the neighbor did not notice for three days.

After

We cleaned both units, replaced the failed outlet and box, cleaned the duct run, and replaced the charcoal and HEPA filters. Thermal fogging cleared the odor in 72 hours and both owners had documentation for their carriers.

Kitchen Appliance Fire, Westchester

Before

A range hood motor shorted and burned a cabinet run, sending smoke into the attic through a chase. The kitchen was unusable and the attic insulation held the smell. The owner was preparing to replace the entire kitchen.

After

We removed the charred cabinets and attic insulation, cleaned the framing, and treated the HVAC system. The kitchen was ready for rebuild in 9 days, and only 3 cabinets needed replacement instead of the full run.

Problems we solve

Electrical Fire Problems We Solve in Playa del Rey

The fire is out, but the problems are just starting: odor in the walls, soot on surfaces you cannot see, and an insurance file that needs to be right the first time. Here is what we fix.

Ask a pro →
01

Smoke odor that returns every evening

We remove the source material, then run hydroxyl generators and thermal fogging with a smoke sealant. Most Playa del Rey homes pass an odor walkthrough within 72 hours of treatment.

↗
02

Soot residue on walls that smears when wiped

We HEPA-vacuum dry first, then use chemical sponges and dry-cleaning methods. Surfaces that cannot be cleaned are removed and replaced rather than painted over.

↗
03

Melted wiring left in the wall cavity

We cut damaged wiring back to clean copper, document the run, and coordinate a licensed electrician inspection before power is restored.

↗
04

Smoke-damaged HVAC spreading residue

We scope the HVAC system, clean ducts and components, and replace charcoal and HEPA filters so the system does not recontaminate cleaned rooms.

↗
Proof you can check

Licensed, Certified, and Documented

✓
IICRC Fire and Smoke Restoration Technician (FSRT)Institute of Inspection, Cleaning and Restoration Certification
✓
IICRC Odor Control Technician (OCT)Institute of Inspection, Cleaning and Restoration Certification
✓
California State Contractor License (B-1 General Building)California Contractors State License Board
✓
OSHA 30Occupational Safety and Health Administration
✓
EPA Lead-Safe CertificationU.S. Environmental Protection Agency
Good questions

Frequently Asked Questions

(833) 929-6186 →

Most residential electrical fire cleanups in Playa del Rey run $2,500 to $12,000 in 2026, with a small single-room job near the low end and a panel fire that reaches the attic near the high end. Cost drivers are the square footage of soot coverage, how much drywall and insulation must be removed, and whether HVAC cleaning is needed. Insurance usually covers the cleanup when the fire is a covered peril, and we document the scope so your adjuster can price it accurately.

Fire Damage Restoration Playa Del Rey does, and we cover the full scope from board-up to final paint. Our crews are IICRC FSRT and OCT certified and hold California State Contractor License (B-1 General Building), so we can remove charred framing and rebuild the wall. Call (833) 929-6186 and we will schedule an inspection, usually the same day.

Yes. Cleanup crews remove soot and char, but a licensed electrician must inspect the panel, the affected circuit, and the grounding before power is restored. We coordinate that inspection and will not re-energize a circuit until it passes. If the fire started at an outlet or a failed breaker, the electrician also confirms the rest of the branch wiring is sound so the same failure does not repeat.

A single-room electrical fire typically takes 3 to 7 working days for cleanup and deodorization. A fire that travels into the attic or a shared wall cavity runs 10 to 21 days, mostly because of demolition and drying. Equipment like air scrubbers and hydroxyl generators usually runs 24 to 72 hours of that window, and we schedule the final odor walkthrough with you before we pull equipment.

Ready when you are

Get Electrical Fire Cleanup in PLAYA DEL REY, California Today

Soot and smoke odor get worse with every day they sit. Call (833) 929-6186 and we will schedule an inspection, document the damage for your carrier, and start cleanup. Licensed, insured, and available around the clock.

Call Now (833) 929-6186 →
Request an appointment

Call for Fire Damage Restoration

Our line is answered 24 hours a day, including holidays. Call (833) 929-6186 and a technician will ask a few questions about the fire, the structure, and whether anyone is still inside, then dispatch a crew. Most PLAYA DEL REY calls get a team on site within the hour.

Request received — our team will be in touch shortly.
Tap to call(833) 929-6186